Engines operating in the 2500 to 7500 rpm range. In most cases, these manifolds accept factory OE water necks, air conditioning, alternator and H.E.I. ignition systems.
Get the maximum power from your engine with this Air Gap Small Block Ford Windsor EFI cast intake manifold. This single-plane intake manifold is designed to keep your air and fuel distribution going into the engine at a steady and even flow for maximum performance and efficiency. The carburettor-mounting pad is designed to accept aftermarket 4150 square-bore throttle bodies designed for EFI applications.
The fuel injector bores have back-cut exits in the intake runners for better fuel atomization. The fuel rails, brackets and mounting hardware are included with the manifold for easy installation with the injectors that you choose to use for your combination (fuel injector sold separately). Fuel rail is designed to allow a full length 14mm fuel injector (sold separately).
Specifically designed for 289-302 cubic inch small-block Ford Windsor engine
Manifold Specifications
- Square bore carburettor pad
- Overall height (Carb pad to bottom of manifold) is 162mm
- PortSize: 1.04" x 1.82"
- Intake manifold gasket, Fel Pro 1205
- 5/16-18" carburettor studs (x4)
- 1/2" NPT port (x1)
-3/8" NPT ports (x3)
Intake Manifold Includes
- 12 x 5/16"-18 Hex Screws (50mmUHL)
- 12 x 5/16" Flat Washers and Spring Washers
- 4 x 1/4" carburettor studs
Fuel Rail Kit includes
- 2 x Two Fuel Rails (-8ORB)
- 1 x -8AN cross over 200 series PTFE braided line and two 90 degreenon full flow fittings
-3 x -8an to -8ORB fittings
- 1 x -8ORB hex port plug
- 4 x mounting brackets
- 4 x 1/4-20" socket cap screws(25mm UHL)
- 4 x 1/4-20" hex head screws (12mm UHL)
